This stripper is a new blend of solvents designed to liquefy finishes and waxes without the use of floor machine agitation.  This new formula allows little or no rinsing or neutralizing before recoating with floor finish.  Its deep penetrating quality allows you to strip floors in considerably less time compared to conventional strippers

* No floor machine scrubbing

* Labor saver

NOTE: This stripper should no be used on woods floors or painted surfaces.  May soften or bleach linoleum or rubber floors.

CAUTION

KEEP OUT OF REACH OF CHILDREN

Always use with adequate ventilation.  Can cause eye damage.  Avoid contact with eyes, skin and clothing.  Harmful if swallowed.  Do not take internally.  Wear gloves while using

Click here for MSDS Report

 MOP AND STRIP

WAX AND FINISH REMOVER

Liquefies the toughest finishes

Eliminates the use of floor machines and stripping pads

Removes all metal interlocked floor finishes and waxes

Labor saver, mop on -- mop off

Non Ammoniated

The stripper may be used as is or diluted with water.  Dilute with water as needed.  If dilution is desired, test a 1:4 dilution in a small area and adjust the dilution to create the right stripper.  When diluting use hot water.

Apply solution liberally to floor with a mop.  Make sure that the surfaces is is uniformly wet.

Allow stripper to soak in for 3 to 5 minutes.  Do not allow stripper to dry. Thoroughly pick up all of the solution with a clean mop, wet vac or if available and automatic scrubber.

Allow to dry.  Floor may be buffed to enhance the look of the floor before accepting the first coat of floor seal or finish.  Rinsing is recommended but not necessary.

DIRECTIONS: USING SCRUBBING MACHINE

Use 8 to 12 ounces per gallon of hot water.  Mop on stripper solution and allow to dry for 5 to 10 minutes.  Use scrubbing machine with appropriate pad to lift and remove finish.  Pick up the stripper solution and residue with a mop or wet vac, then rinse thoroughly.